The service life of the double-layer glass reactor is closely related to the daily maintenance, in addition to the inverter, glass and motor. In order to extend the service life of the double-layer glass reactor and to protect your interests, please read this section carefully. The double-layer glass reactor sandwich can provide high-temperature reaction (high temperature can reach 300 ° C) or low temperature reaction (low temperature can reach -80 ° C); and these daily work damage to double-layer glass reactor is very large, Therefore, daily maintenance is very important.
The following are the routine maintenance methods for double-layer glass reactors:
1. Check whether the interfaces of the instrument are consistent. Pay attention to it.
2. The interfaces should not be tightened too tightly. It should be loosely activated at regular intervals to avoid long-term tight locking and cause the connector to bite.
3. Wipe each interface with a soft cloth (can be replaced with a napkin) and apply a small amount of vacuum grease. (The vacuum grease must be covered after use to prevent the entry of sand.)
4. Regularly clean the sealing ring by removing the sealing ring and checking if there is dirt on the shaft. Wipe it with a soft cloth, then apply a little vacuum grease and reinstall it to keep the shaft and seal ring smooth.
5, the PTFE switch everywhere can not be tightened too much, easy to damage the glass.
6. Loosen the PTFE switches after the machine stops. The long-term stationary state will make the PTFE piston deform.
7. Turn on the power switch first, then let the machine run from slow to fast. When the machine is stopped, stop the machine and turn off the switch.
8. Every time you use it, you must use a soft cloth to clean all kinds of oil traces left on the surface of the machine, stains, solvent remaining, and keep it clean.
9, the electrical part must not enter the water, it is strictly prohibited to get wet.
10, must purchase the original authentic accessories, free use of other accessories can cause fatal damage to the machine.
Other Medical Implant,Cannulated Cancellous Screw,Cortical Bone Screw,Locking Plate Screw
Changzhou Ziying Metal Products Co., Ltd , https://www.ziyingmetal.com