Install the vertical knife, first turn the adjustable eccentric wheel, and then move the tool holder to the bottom dead center, then lift the tool holder upwards 1-2 mm, so that the vertical knife is in contact with the conveyor belt, the fastening nut fastens the vertical knife On the knife holder. If the height of the tool holder is small, the vegetable may be connected to the knife. If the height of the knife holder is too large, the conveyor belt may be cut.
1. The cutting machine should be placed on the level ground to ensure the equipment runs smoothly and reliably, and check whether the plug is in good contact.
2. Check if there are any foreign objects in the rotating barrel or on the conveyor belt. If there is any foreign matter, it must be cleaned up in time to avoid damage to the tool.
3. Install the vertical knife, first turn the adjustable eccentric wheel to make the knife holder go to the bottom dead center, then lift the knife holder upwards 1-2 mm, so that the vertical knife contacts the conveyor belt, tighten the nut and put the vertical knife Fasten to the knife holder. If the height of the tool holder is small, the vegetable may be connected to the knife. If the height of the knife holder is too large, the conveyor belt may be cut.
4. After the work is over, pay attention to clean the cutting machine in time to ensure the safety and hygiene of the equipment.
Â
Forehead Thermometer;infrared thermometer:digital thermometer:clinical thermometer
Shenzhen Urion Technology Co., Ltd. , https://www.urionhealth.com