The management of fertilizer and water is not easy to water in the stem growth phase of gourd, it is necessary to adopt management measures combining “promoting†and “controllingâ€, and timely cultivating and maintaining tillage after watering to extend the time of watering interval, and do not need top dressing at this time.
The first female flower of the late-maturing wax gourd cultivar, melon, is born between 15-25 knots. The melon vine is very long, and it can use guava vines to grow the adventitious roots, which can prevent the cold and expand the root system. The specific approach is: When the melon vines grow 60 cm, on the same side of each melon quail about 20 cm away from the root will topsoil open a 20-30 cm long, 7-8 cm deep arc groove, and then the melon Approximately 20 cm of the larvae of the locusts below the head lead into the ditch, and the ditch cover soil is called crushed vines. The side sticks and tendrils of the melon vine were removed when the wire rods were used. In order to keep the length of the melon vines on the ground, the length of the rods of the melon vines will be larger when the vines are crushed, and the shorter arcs will be smaller. After the vines are pressed, water shall be poured to make the racks stand.
Insertion, snoring and tying of vines in late-maturing varieties of wax gourd should be inserted in a triangular rack in time after the vines have been crushed. Three short bamboo poles with a length of 1 metre are inserted around each squash and the squats are put together. Late-maturing varieties of wax gourd can be introduced on shelves when they are crushed and then grow 6-7 leaves (about 50 cm). The first trawl is about 15-16 cm from the ground on the first pole; the second lane is on another raft on the rack, about 50 centimeters from the ground, so that the melon's fruit is born on two rods. The third lane was tied to the top of the second bamboo pole. Every time you tie the vines, you must take off the rolls and go sideways. When arranging the first vine on the vine, it should be cultivated and weeded.
Glow In Dark Tape
1. Material and classification of glow in dark tape
We have PET material glow in dark tape and PVC material glow in dark tape. PET material is cheaper but not printable. PVC material support customized printing with low MOQ.
For both materials, we have different kinds according to the glowing time it can last after full charging (0.5hours charging at least). We have 2hours, 4hour, 6hours, 8hours and 10hours according to the glowing period it can last.
2. Colors for choosing
We have light green, pink, orange, red, blue, white for choosing.
3. Features
a. Good ahesion, we use solvent acrylic adhesive, the adhesive is strong and long lasting.
b. Waterproof. Both PET and PVC material are waterproof. Can used for both indoor and outdoor usage.
c. Long service life: 2~3 years even for outdoor usage.
d. Different sizes for choosing: 1.24m x 45.7m log roll, or other customized sizes such as 25mm/ 50mm x 5meters/ 10yards/ 10meters/ 18meters, etc.
e, Accept die cuting to small pieces such as dots, stars, arrows, etc,
Glow Grip Tape,Luminous Adhesive Tape,Waterproof Glow In The Dark Tape,Glow In The Dark Reflective Tape
Kunshan Jieyudeng Intelligent Technology Co., Ltd. , https://www.jerrytapes.com