1. Cancellation cannot be premature. When the side branch of the tomato is too small, it produces more nutrients than the nutrients consumed, so it should not be removed at this time, especially when the leaves of the plant do not completely cover the ground. In order to make full use of the nutrition produced by the side branches, it is better to remove the side branches when the length is about 5 cm. For the first branch of the lower part of the flower per tomato, it should be properly removed early, and should be removed when the length is about 3 cm. If the first side branch of the lower part of the flower of the tomato is not removed in time, the growth will soon exceed the main branch, thus causing a large amount of nutrient waste.
2, the evacuation can not be too late. If the side branch of the tomato is removed too late and the side branch is more than 5 cm long, it will compete vigorously with the main branch for nutrients, and the growth will gradually exceed the main branch. Too late collateral branching will also cause aging of the phloem of the lateral branches. Because the lateral branches are closely connected with the phloem of the main branches, the epidermis of the main branches is easily broken when the lateral branches are removed, which affects the growth of the tomato. In addition, when the side branches of the tomato are removed, the pile cannot be left in order to prevent the side branches from being germinated again from the same leaf axils.
3. Spray protection after evacuation. If not protected after the removal, the bacteria will infect the wound. Therefore, after the thinning, a new high-fat film is sprayed in time to form a polymer film to isolate the pests and diseases of the pests and diseases from the wound.
Disclaimer: Some articles on this website are transferred from the Internet. If legal rights of third parties are involved, please inform this website. phone
Reolink WiFi cameras can be added to Reolink PoE NVRs if they are in the same LAN. Here we'll guide you to finish this process following the steps below.
Step 1: Connect the camera to your router via WiFi by configuring WiFi settings for the WiFi camera.
Step 2: Connect your PoE NVR to the LAN port of the router.
Step 3: Open the monitor of your NVR, then select Channel Settings > IP channel. Check Auto Add and click Scan. Then the WiFi camera will show up in the list. Assign a channel for it if necessary.
Reolink WiFi cameras can be added to Reolink PoE NVRs if they are in the same LAN. Here we'll guide you to finish this process following the steps below.Reolink WiFi cameras can be added to Reolink PoE NVRs if they are in the same LAN. Here we'll guide you to finish this process following the steps below.Reolink WiFi cameras can be added to Reolink PoE NVRs if they are in the same LAN. Here we'll guide you to finish this process following the steps below.Reolink WiFi cameras can be added to Reolink PoE NVRs if they are in the same LAN. Here we'll guide you to finish this process following the steps below.
Surveillance Camera System,wireless camera,Outdoor Ip Camera ,Wireless Security Ip Camera,Home Security Cctv Wifi Smart Camera,Surveillance Camera Set
Shenzhen Fuvision Electronics Co., Ltd. , https://www.szsolarcamera.com